©Elation® - www.elationlighting.com - Event Panel System™ User Manual Page 10©Elation® - www.elationlighting.com - Event Panel System™ User Manual Page 9
Event Panel System™ Operating Instructions
Auto Run:
1. Plug the fixture in and press the MODE button until AUTO is dis-
played. You are now in AUTO mode and the fixture will now cycle
through the built in programs.
2. Press the UP or DOWN buttons to adjust the “frequency” or speed
the auto run mode.
Sound Active Mode:
In this mode the Event Panel System™ will react to sound, and chase
through the different colors. There are two sound active modes to
choose from.
1. Plug the fixture in and press the MODE button until SOUND is dis-
played. The fixture will now change color via sound.
2. You can press the UP or DOWN buttons to adjust the sound sensi-
tivity level. The sensitiviey can be adjusted from “SENS.00” the
least sensitive, to “SENS.31” the most sensitive.
DMX Mode:
There are six DMX Modes to choose from: 2 Channels, 3 Channels,
4 Channels, 7 Channels, 14 Channels, or 26 Channels. Operating
through a DMX controller give the user the freedom to create their
own programs tailored to their own individual needs.
1. This function will allow you to control each individual fixture’s
traits with a Elation® DMX 512 Controller.
2. To run your fixture in DMX mode, plug in the fixture via the XLR
connections to any standard DMX controller.
3. Press the MODE button until DMX MODE: ADDR is displayed.
Press the UP or DOWN buttons to select your desired address.
Once you have set your desired DMX address press the SETUP
button to to choose your desired DMX mode.
4. When you press the SETUP button DMX MODE: MODE should be
displayed. Press the UP or DOWN buttons to select your desired
DMX mode.
The Modes go as follows: DMX MODE 1 is 3 Channel mode,
DMX MODE 2 is 4 Channel mode, DMX MODE 3 is 14 Channel
mode, DMX MODE 4 is 26 Channel mode, DMX MODE 5 is 2
Channel mode, and DMX MODE 6 is 7 Channel mode.
5. Please see pages 11-19 for DMX values and traits.
Event Panel System™ Battery Pack
The Event Panel comes with a portable battery pack so that you can
set up the fixture anywhere without the use of a wall outlet.
To charge the battery pack, connect the battery pack to a matching
power outlet using the supplied 12v DC power supply.
When the pack is charging the Red LED will glow, when the pack is
fully charged the Green LED will glow.
Connect the battery pack to the Event Panel via the 2-pin cable and
turn on the power to the battery pack.
It takes about 8 hours to fully charge the battery pack.
Pay attention to the Battery Life Indicator on the battery pack to
keep track of the battery pack charge level.
Connecting the Event Panel to the Battery Pack:
Connect the Event Panel to the battery pack using the included trig-
ger pins. Line up the trigger pins with the holes and rotate the pins
unil you feel them slide easily into the holes. To lock the pins into
place apply pressure and rotate turn the pins clockwise to lock them
into place. Test the attachment by gently pulling on the Event Panel.
(38 pages)
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals